Review Planned Run settings

You can review the Planned Run settings of a completed run.

In the Data tab, click Completed Runs & Reports, then select a run of interest.
The report for that run opens.

Click Report Actions > Review Plan.

A Review Plan summary lists the details of the Planned Run. The subcategory details are different based on different runs.

Category	Subcategory
Review Plan	The name of the completed run.
Report	The name of the report that was generated for the completed run.
Application	Research Application
	Research Category
	Sample Grouping
	Target Technique
	Sample Set
Kits	Sample Preparation Kit
	Library Kit
	Library Key
	3' Adaptor
	Flow Order
	Template Kit
	Templating Protocol
	Sequencing Kit
	Control Sequence
	Library Read Length
	Flows
	Chip Type
	Barcode Set
	Mark as Duplicates Reads
	Base Calibration Mode
	Enable Realignment
	Manifold Heater Note: A value of Default means that this setting is not used. Otherwise the value for this setting is Dynamic.
Monitoring	Bead Loading (%)
	Key Signal (1-100)
	Usable Sequence (%)
Reference	Reference Library
	Target Regions
	Hotspot Regions
	Fusions Reference Library
	Fusions Target Regions
Plugins & Output	Plugins
	Projects
	Uploaders
Notes
LIMS Meta Data
Plan Meta Data	TS version when created
Plan Meta Data	Plan created via
Barcodes & Samples	Sample Tube Label
	Chip Barcode
	A table of information about the barcode used in the run. Table columns include: Barcode Sample Name Sample ID DNA/RNA Reference Target Regions Hotspot Regions
Analysis Parameters Used (Default)	BeadFind Args
	Analysis Args
	Pre-BaseCaller Args for calibration
	Calibration Args
	BaseCaller Args
	Alignment Args
	IonStats Args
History	A log of system actions taken during the run. Table columns include: Date User Log